Always read carefully instruction
manual of eletric devices you use
including all recommendations, setting,
instalation to model, safety instructions
etc. Motor and speed controller must be placed to
model with regards to best possible cooling.
Power cables between motor and controller must be
as short as possible, max 150mm. If it is necessary
to extend wires, alway extend both wires (plus and
minus). For every 200-250mm of extension add
lowimpedance capacitor between plus and minus
cable. Don't connect controller directly to power
supply, always use good accumulators.
Place receiver as far as possible from power system
(motor, controller, battery) - minimal distance is
100mm.
Minimal distance between receiver and servos is
50mm.
Antenna must be placed as far as possible from all
cables, metal and carbon fibre parts. Antenna with
best efficiency is straight antenna placed
perpendicularly to rest of cables in model (vertically
to the model) leading out of fuselage.
When carbon fibre fuselage is used antenna must be
galvanically separated from fuselage.
Consider using speed controllers with BEC for higher
power than 1000W. It's recommended to use OPTO
controller.
For big glides always use OPTO speed controllers
and receiver accus.
Apply only new high quality connectors. Occasionally
check connectors and soldered connections.